Input voltage: 220V
Size: 180 * 125 * 125mm
Phase parameters: single phase
1 x 220V 3KW SPA Heater
1 x English Manual
Thermostat outlet to the bath tub in the middle of the pipe or valve or check valve can not be installed
Our this product is fit for the poor with 1.5 cubic metre of water, and cannot work with salt water
This thermostat is specifically designed for the hot tub, the thermostat is installed in the pipeline jacuzzi. When adding hot water bath, start the pump, the thermostat automatically heat insulation work, so the water temperature bath maintained at 39 degrees Celsius, give your Jacuzzi to create a more comfortable environment.
The initial set temperature settings:
1. Thermostat equipped with ultra-high temperature protection thermostat switch, thermostat to limit overheating and protect users against danger, however, users should be done after the installation is complete, the first under the premise of safety checks to ensure that the operation of the thermostat's normal function, By using the tub filled with water to a suitable level and start the system automatically checks and let the system run until the thermostat temperature stabilized at the highest level and display lights go out, use an accurate thermometer to measure the water temperature should be at 40°C.
2. Thermostat operation is fully automated, clockwise, the heating is on, indicator light, temperature reaches a preset temperature, will remain at that temperature.
The thermostat can be maintained within a temperature not exceeding 40°C (104°F) range. If cold water is started, will be 6 ~ 8°C / h elevated temperatures.
Thermostat will first reach the preset temperature, then stop working until the temperature dropped a few degrees, the thermostat automatically turns on.
Ultra-high temperature protection switch and reset button:
Ultra-high temperature (over 49°C), ultra-high temperature switch will automatically trip (power off).